The specifications, decoded
Manufacturer-reported details. These are not presented as independent laboratory measurements.
- Model
- Omnilux Contour Face
- Light configuration
- Red, Near-infrared
- Nominal wavelengths
- 633 / 830 nm
- LED count
- 132
- Session length
- 10 minutes
- Design
- Flexible silicone
- LED breakdown
- 66 red · 66 near-infrared
- Manufacturer-stated irradiance
- About 30 mW/cm²
- Heat and UV
- None, according to Omnilux
- Eye protection
- Not required, according to Omnilux; optional eyewear for comfort
- Regulatory
- FDA-cleared, according to Omnilux · tested to IEC/EN 62471
- Age
- Intended for users 21 and over
- Warranty
- 2 years
How to use the Contour Face
Omnilux recommends 3 to 5 sessions a week for 4 to 6 weeks, and says results start to show at around 4 weeks with consistent use. Use it on a bare face, or over Omnilux hydrogel masks. Omnilux notes it has not studied the effect of daily use.
What’s in the box
Omnilux does not list the box contents on its product page. Its FAQ refers to a user guide, a controller, and a charger with a country-specific adapter.
Manufacturer cautions
- Intended for users 21 and over.
- Not for treating inflammatory acne vulgaris.
- Do not use at the same time as Omnilux Clear.
- Do not charge the controller while the mask is plugged in.
Is the Contour Face right for you?
It may suit you if:
- You want a simple red and near-infrared mask with a published irradiance and a defined 4–6 week course.
- You want a flexible fit without eye protection to manage.
Look elsewhere if:
- You want blue light: Contour Face has none (Omnilux Clear is the blue model).
- You are under 21.
Contour Face vs CurrentBody Series 2
Both are flexible red and near-infrared masks with 10-minute sessions and LEDs at 633 and 830 nm, and both suggest 3 to 5 sessions a week. Contour Face has 132 LEDs and publishes an irradiance of about 30 mW/cm². Series 2 has 236 LEDs, including 16 deep near-infrared at 1072 nm.
Read the CurrentBody Skin LED Light Therapy Mask Series 2 file · Compare the two
What to know about this model
This file covers Contour Face. Omnilux Men and Omnilux Clear use different light configurations and should not be treated as the same device.
Independent test record
The directory owner had this mask independently tested at SIQ to check it against the manufacturer’s published specifications. The report is held on file and is not published.
- Laboratory
- SIQ, Ljubljana, Slovenia ↗
- Purpose
- Check against the manufacturer’s published specifications
- Report
- Held on file · not published
Sources
Omnilux Contour Face specifications ↗
Specification sources reviewed on . Product revisions may differ; consult the manual for the exact device.
Common questions
Does Omnilux Contour Face have blue light?
No. Omnilux lists red at 633 nm and near-infrared at 830 nm for Contour Face. Blue light is not part of this model’s configuration.
How many LEDs does the Omnilux Contour Face have?
Omnilux lists 132 LEDs for the Omnilux Contour Face. LED count is the number of emitters, not the light dose that reaches skin, so compare it alongside wavelength and session time.
How long is a Omnilux Contour Face session?
Omnilux specifies a 10-minute session for the Omnilux Contour Face. Session time and output together determine the light dose.
How often should you use the Omnilux Contour Face?
Omnilux recommends 3 to 5 sessions a week for 4 to 6 weeks. Follow the manual for your device.
Does the Omnilux Contour Face need eye protection?
Omnilux states Contour Face does not require eye protection. Optional eyewear is available for comfort.
Has the Omnilux Contour Face been independently tested?
Yes. The directory owner had the Omnilux Contour Face tested at SIQ, the Slovenian Institute of Quality and Metrology, to check it against Omnilux’s published specifications. The report is held on file and is not published.